[FC] My turn in the barrel

[Michael Emanuele]

Bob, I recently went through the same problem on my Rampside. I found that
there seems to be a strain on the rear harness going to the right tail light
right at the point where the head temp. sending unit wire and the ignition
wire going to the coil come out of the harness. After years of heat and of
course age the wires break down and crack. Best fix is to replace the
harness, but I was able peel back the tape and splice new wires into the
existing harness. All is working well right now.

Mike Emanuele
61 Rampside 140
69 Monza Convertible
Looking for a Greenbrier
----- Original Message -----
From: "ROBERT CRAWFORD" <rcrawf4827@worldnet.att.net>
To: <corvanatics@corvair.org>
Sent: Monday, July 07, 2003 3:24 PM
Subject: [FC] My turn in the barrel


> Over the years I have seen a number of threads on: "I have lost my
> directionals and my right rear brake light doesn't work." I never paid
much
> attention. However, I have suddenly taken in interest in that topic
because I
> have lost my directionals and my right rear brake light doesn't work.
>
> I have replaced the kadinker (aka flasher) and cleaned up the grounds to
the
> right rear taillight housing. However, the wire at the socket does not
have
> juice.
>
> Any suggestions?
>
> Thanks, Bob C  64 GB Deluxe
> _______________________________________________
> Corvanatics mailing list
> Corvanatics@corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics