[FC] engine mount

[Vern McIntosh]

You need only enough room to slip a fan belt between the balancer and the
mount.

If you can't get a '64 mount, I don't think that is a problem. I just
examined the 'dish' of a loose '64 mount and it is less than 1/8", a 3/8"
washer just filled the space between the dished area and a straight-edge.

So, you probably need only one washer (two at most) to get enough clearance
for the belt. BTDT.

Vern McIntosh
Bend, Oregon


----- Original Message -----
From: "Keith Hammett" <khammett@stainlessfab.com>
To: <corvanatics@corvair.org>
Sent: Friday, September 12, 2003 8:50 AM
Subject: RE: [FC] engine mount


> Thanks,  I don't have a 64 mount :(  Looks like I will be doing a little
> research on this.
>
> Keith Hammett
>
> -----Original Message-----
> From: corvanatics-admin@corvair.org
> [mailto:corvanatics-admin@corvair.org]On Behalf Of N2VZD@aol.com
> Sent: Friday, September 12, 2003 10:36 AM
> To: corvanatics@corvair.org
> Subject: Re: [FC] engine mount
>
>
> if you use a 64 mount you should be ok. it is dished out .i get nervous
> spacing them out .  regards tim colson