[FC] deflashing heads....

[corvanatics@corvair.org]

Rickie:

You can get the 1/8" by 12" long drill at Sears. Sorry, I do not have a part number.

Bob C
64 GB Deluxe
> What I want to know is where can I buy the foot long 1/8 inch drill bit and
> the 1/8 inch rod saw that you mention?  In this small town, those items are
> unheard of...so preferably a source from the internet if you know of one.
> 
> Thanks,
> Rickie Williams
> Columbia, KY
> 
> > ----------
> > From: 	Merv and or Loretta[SMTP:krupross@sunwave.net]
> > Reply To: 	corvanatics@corvair.org
> > Sent: 	Monday, February 09, 2004 9:54 PM
> > To: 	corvanatics@corvair.org; corvairs@cybrus.net
> > Subject: 	[FC] deflashing heads....
> > 
> > Hi all!
> > 
> > Dropped the motor, put it on the bench, drained the oil, cleaned off a
> > bunch
> > of gunk, removed some shields, tipped it up on the bell housing end, ready
> > to
> > take the rest of the shields off.
> > 
> > Then I'm going in to deflash the heads. I bought a 1/8" x 12" drill bit,
> > and I
> > have a 1/8" rod saw to do the work.
> > 
> > Any advice from those who have done this before....?
> > 
> > Much obliged folks!
> > 
> > Merv Krull
> > Salmon Arm
> > _______________________________________________
> > Corvanatics mailing list
> > Corvanatics@corvair.org
> > http://www.vv.corvair.org/mailman/listinfo/corvanatics
> _______________________________________________
> Corvanatics mailing list
> Corvanatics@corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics