[FC] Early heater boxes

[Merv and or Loretta]

No doubt you can get a pretty decent one... but the thought of fibreglassing
over an old one is kind of tantalizing! I would think that would help make
the heating system just a little quieter....? I love quiet... the better to
hear the drivetrain with!
Merv Krull
Salmon Arm
62 GB
64 700 4 door

----- Original Message ----- 
From: "Bryan Blackwell" <bryan@skiblack.com>
To: <corvanatics@corvair.org>
Sent: Thursday, January 01, 2004 5:53 PM
Subject: Re: [FC] Early heater boxes


> I could probably do that, although I think there are enough of these
> out there for a hopefully reasonable price to just get a nicer one.
> Basically the lower surface has lots of pinholes, and there is one
> pretty good size hole in the fresh air side of the box.  I'd basically
> end up glassing over the whole bottom of the housing.
>
> --Bryan
>
> On Thursday, January 1, 2004, at 06:59 PM, N2VZD@aol.com wrote:
>
> > is there enough left of the heater box to patch using marine type
> > cloth and
> > resin?  if you got it clean enough it would be a forever patch and
> > cover ok
> > with black paint. regards tim colson
> _______________________________________________
> Corvanatics mailing list
> Corvanatics@corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics