[FC] side door hinge pin

[Ben's Bus]

Ken-

Are you settled in yet? I am sure it was a good convention. Let me know what
the shipping will be on two sets of side door hinge pins and bushings and I
will get a check out to you. I would liike to work on the saggy side door
ASAP.

Thanks!

Ben Stiles
Strasburg, PA 17579

----- Original Message -----
From: <VairMech at aol.com>
To: <corvanatics at corvair.org>
Sent: Sunday, July 31, 2005 11:21 PM
Subject: Re: [FC] side door hinge pin


>
> In a message dated 7/31/2005 7:02:28 P.M. Pacific Daylight Time,
> stiles at paonline.com writes:
>
> Anyone  know of a new GM replacement hinge pin that would fit FC side door
> hinges?  Aftermarket or other brand hinge pin that will work,  even with a
> slight  redrilling of the hinge pin holes? How about a source for BRONZE
hinge
> bushings (not plastic) for same.
>
> My front side door is dragging,  largely because of worn plastic hinge
> bushings which were replaced a few years  ago, but started wearing down
almost
> immediately.
>
>
>
> >>>>>>>>>>>>>>>
>     How many pins and bushings do you want? I have  bronze bushings that
fit
> with just a drill clean up and the pins are 1/4" to  long. seems to me the
> price is $3 set, 1 pin, 2 bushings. Plus shipping.
>     Ken Hand
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
>
>