[FC] Screw for rear air outlet grille

[J R Read_HML]

I'll try to ask him when he's off duty.

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: "Kent Sullivan" <kentsu at corvairkid.com>
To: "'The Corvanatics list'" <corvanatics at corvair.org>
Sent: Sunday, December 18, 2005 10:42 PM
Subject: RE: [FC] Screw for rear air outlet grille


> Yes, I'm sure he could. I try to avoid bothering him with questions like
> this. He has a business to run and I've asked him a lot of questions over
> the years. And, this should be something we can figure out without taking
> more of his time.
>
> --Kent
> -----Original Message-----
> From: corvanatics-bounces at corvair.org
> [mailto:corvanatics-bounces at corvair.org] On Behalf Of J R Read_HML
> Sent: Sunday, December 18, 2005 3:21 PM
> To: The Corvanatics list
> Subject: Re: [FC] Screw for rear air outlet grille
>
> Kent,  You should probably contact Larry Claypool.  I'm sure he could tell
> you what "Stock Is".
>
> Attachments (if any) are scanned with anti-virus software.
>
> Later, JR
>
> ----- Original Message -----
> From: "Kent Sullivan" <kentsu at corvairkid.com>
> To: "'The Corvanatics list'" <corvanatics at corvair.org>
> Sent: Sunday, December 18, 2005 3:56 PM
> Subject: [FC] Screw for rear air outlet grille
>
>
>> Hi,
>>
>> I'm doing some research on these grilles. They exist on some years and
>> models of FCs at the rear of the engine, below the bumper.
>>
>> If your rig has one of these grilles, could you please look at the six
>> screws that hold it in? They should all be the same. I think they are hex
>> head without a screwdriver slot.
>>
>> If the screws in your grille appear to be original, I would appreciate 
>> you
>> removing one of them and sending me the following info (or send to the
>> list
>> so that others don't duplicate):
>>
>> 1) Type of screw (I'm pretty sure they are sheet metal)
>> 2) Size of head (5/16", 3/8", etc.)
>> 3) Size of screw body (#8, #10, #12, etc.)
>> 4) Length of screw (measured from underside of head to pointed tip)
>> 5) Anything else notable, like if they are self-drilling
>>
>> Thanks,
>>
>> --Kent
>>
>>
>> _______________________________________________
>> Corvanatics mailing list
>> Corvanatics at corvair.org
>> http://www.vv.corvair.org/mailman/listinfo/corvanatics
>> This list sponsored by the Corvair Society of America,
>> http://www.corvair.org/
>
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
>
>
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/