[FC] Rampside latches

[David C. Herrin III]

Bill,
Carefully grind off "rivet" head
then carefully drill then tap for a threaded fastener...
shim latch with thin washer so the lever doesn't flop around.
Someone used to offer "rebuilt" - "rechrome" units - exchange = ?
David
----- Original Message ----- 
From: <SHGraphics at aol.com>
To: <corvanatics at corvair.org>
Sent: Tuesday, February 22, 2005 10:07 PM
Subject: Re: [FC] Rampside latches


> Hello to all,
>    I'm working on my Rampside latches, and I was wondering how to
> disassemble them. Are the levers forced onto a ribbed shaft, attached to 
> the back by a
> rivet-like grommet that has to be forcibly removed, or (worst case 
> scenario),
> are they welded on to the shaft?
>    I'd appreciate any info out there.
> Thanks,
> Bill Beckley
> '61 Rampside
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
>
>