[FC] '61 rampy

[Merv Krull]

Go Tim Go! Do you have any pics posted anywhere?
Merv Krull
Salmon Arm, BC
62 GB now in HS autobody shop

----- Original Message ----- 
From: "Timothy T Werner" <wern3 at juno.com>
To: <corvanatics at corvair.org>
Sent: Tuesday, November 22, 2005 11:02 AM
Subject: [FC] '61 rampy


> The motor has the oil dipstick built into the cap sticking out of the
> rear of the block on the original '61 engine.
> I am going to check out the tranny for the Rampy, see if it was swapped
> out of an early car, which would explain the backup light switch. There
> are no wires to the switch and no backup lights on the truck. Thanks for
> the help ID'ing the motor #!! It is nice to know that the motor is
> correct for this truck, even if it will be replaced by a 140 I have ready
> to go. I will use the tranny and the diff that came with the truck, but
> will assemble a new flywheel, pressure plate and input shaft.
> I am having quite a time getting all the grime off the transmission case
> and the differential case. Work on the frame is going along better as I
> get the hang of it.
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/