[FC] tool question

[James Davis]

The tap is self sizing.  If you are using it on hole without threads 
you need to keep it square when running it in.  Only if the threads 
are square can the inserts ring seat properly and not back-out with 
the plug.  I use Locktite stud and bearing locker to be sure.
Jim Davis




At 09:55 AM 1/19/2006, you wrote:
>well i just found info on that tap .  it does not show a drill with it, just
>using the tap.  i had a drill i used but its no longer with it. i 
>guess i will
>try without the drill.  anyone do this? i have not had to do this in years so
>cant remember using it without a drill. off to try it.
>regards, tim colson