[FC] shock absorbers and cutting stock coil springs - AD?

[Ken Hand]

 OK, here goes; If you think the front of the FC is stiff now cut a coil off and it will be even stiffer. On a whoopee bump do you hit your head on the ceiling now? If you did before, it will be worse after cutting a coil. Anytime you cut any spring shorter you basically make it stiffer.

I offer the kit you have been hearing about using the Mustang springs and good quality Monroe truck shocks. The info is available if you want to research it. I don't remember who did the article on the springs but I did the article on the shocks.

The Mustang springs will lower the nose of the truck and make it ride like a Cadillac. You may want to add a front sway bar at the same time as there have been reports of slight rocking of the FC in cross winds, worse than stock because the aftermarket springs are a bit softer.

 

Ken Hand
248-613-8586
www.corvairmechanic.com

http://s186.photobucket.com/albums/x118/vairmech/Viet%20Nam%20Pictures%201971/


 

 

-----Original Message-----
From: Andrew Sego <andrew_sego at yahoo.com>
To: corvanatics at corvair.org
Sent: Mon, Jun 27, 2011 11:32 am
Subject: [FC] shock absorbers and cutting stock coil springs


I spent Saturday addressing the brake issues with my van.  It has not seen the 
road in over 10 years, so I've been checking everything out carefully.  I 
rebuilt the master cylinder, wheel cylinders, and adjusters.  I replaced the 
shoes, hardware, and all the hoses.  I turned all of the drums too.  Now when I 
hit the brake pedal I know what to expect.  The only problem I ran into was 
trying to bleed and flush the entire system after I rebuilt the MC but before I 
worked on anything else.  Turns out the left front brake hose was 
clogged/swollen so bad that it wouldn't pass fluid.  

 
I also discovered that I have a bad lower ball joint on the driver side.  It has 

probably 3/16" of vertical play in it. When I get that apart I want to replace 
the shock absorbers and cut the springs to lower it.  I have read about the cut 
Mustang spring setup but I'd rather try cutting the stock ones first.  I am 
runing 215/70/14 tires and the nose sits much too high for my tastes.  Once two 
people are in the front seat of the van it sits about right, but I'd like for it 

to look right when it's sitting still as well.  

 
I think my plan is to cut 1, maybe 2, coils from the front and reassemble it 
with new shock absorbers.  Has anyone cut their springs and been happy with it 
in terms or stance and ride? 

 
Shock absorbers:  I've bought a few sets of shocks for cars from Clark's over 
the years.  At first they are good, but seem to wear out fast.  They list the 
same shocks for cars and FC's.  Seems like they would wear out even faster in a 
truck than in a car.  Can anyone recommend a good shock that I can buy at my 
FLAPS that will fit and function propperly but last longer than the Red Ryders?
 
I hope to have my rebuilt boomerang and new idler  installed before the 
holiday weekend.
 
Thanks for your help in resurrecting this old beast!
 
Andrew Sego
_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America, http://www.corvair.org/