[FC] 61 FC Transmission Linkage comments

[N2VZD at aol.com]

I remember putting the added pin on the shift lever with epoxy because of  
the ball on the end of stock lever being a loose fit on the shaft. That 
shift  kit on a late FC shifter is just plain awsome to drive. If I did it again 
, I  would probably weld it. that was many years ago , It is now a 
powerglide with  very short stock throw...
I needed the short throw because of extra 2 way  radio equipment  hanging 
on the radio pod being hard on knuckles at times.
regards, Tim Colson
 
 
In a message dated 11/25/2012 5:13:47 P.M. Eastern Standard Time,  
bryan at skiblack.com writes:

There is  also Jim Davis' post on the subject that I collected a few years 
ago, it may  add a couple details you don't already  have:

http://autoxer.skiblack.com/shifter.html

--Bryan

On  Nov 25, 2012, at 12:21 AM, Michael Henrie wrote:

> Thanks to  everyone in the forum. I can wiggle the shifter probably a 
foot either way  while in first gear. It's really loose. But luckily I have 
friends that are  helping me because I'm no mechanic and as not rich enough to 
just frame off  it. Thanks to everone at Corvanatics that  responded!

_______________________________________________
Corvanatics  mailing  list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This  list sponsored by the Corvair Society of America,  
http://www.corvair.org/