[NoVa-Corvairs] 28-30 April Vair Fair

[Bryan Blackwell]

Something isn't right - the u-joint should fit flush into the yoke.  
You're also correct about not just cranking them down.  Either 
something is behind the cap, or the bolt/hole is dirty, etc.

--Bryan

On Apr 4, 2006, at 1:40 PM, Daniel Goldberg wrote:

> Also ... I installed my rebuilt half-shafts on Saturday, and couldn't 
> get one of the axle-side clamps to fit flush on the yoke.  That is, 
> maybe three or four bolt threads are showing.  Being that years ago I 
> snapped off a bolt in an axle yoke hole, I'm a bit gun shy about 
> cranking down any more on this bolt.  Besides, everything appears to 
> be fine.   Am I worrying needlessly?