[NoVa-Corvairs] Vair Fair Tech Sessions

[rvtum at verizon.net]

Curt,

I have at two early axles with puller ring and bearings.  This would be a great demo.  We could probably just set him up in the parking lot.  As I recall he installs the tool onto the hitch of his truck for the demo. 

Ron


>From: Curtis Shimp <clshimp at juno.com>
>Date: 2007/04/14 Sat PM 02:29:36 CDT
>To: novacc-list at corvair.org
>Subject: [NoVa-Corvairs] Vair Fair Tech Sessions

>Guys:
>
>I just got off the phone with a man named Russell Davis (Central Corvair
>Club?) who made a tool specifically to remove axle bearings from early
>model axles.  He is willing to demonstrate his tool at one of our tech
>sessions or in place of one.  he would prefer do the morning session as
>then he could run the Rally in the afternoon.
>
>To do his demonstration he would need two or three early axles on which
>to demonstrate this.  Russell said the axle must still have the puller
>ring on it (I don't know what that means) to do his demonstration.  
>
>First of all is this acceptable to the group?  I had tried to contact
>this man about doing this earlier without luck but Wade Lanning sent me
>Russell's cell phone number and as they say, the rest is history. 
>Secondly, does anyone have any candidate axles with which Russell can do
>his demonstration?
>
>Curt 
>_______________________________________________
>Novacc-list mailing list
>Novacc-list at corvair.org
>http://www.vv.corvair.org/mailman/listinfo/novacc-list