[NoVa-Corvairs] Fwd: <VV> Parts Needed for 1960 Bolivian Corvair

[Bryan Blackwell]

Hi Folks,

In case you haven't seen it, there's a gentleman in Bolivia who is  
restoring a 1960:

http://www.widman.biz/Corvair/corvair.html

Richard's daughter lives in Warrenton and he'll be visiting in  
August, so I invited him to our meeting in August in Manassas.  Bill  
Hubbell posted a copy of some things Richard is looking for to VV,  
that's below.  I'd guess we may have some of this stuff around, so  
reply back to him (at richard at widman.biz) if you can bring it along  
in August.

--Bryan

Begin forwarded message:

> From: "Bill Hubbell" <whubbell at umich.edu>
> Date: July 20, 2007 7:35:44 PM EDT
> To: <virtualvairs at corvair.org>
> Subject: RE: <VV> Parts Needed for 1960 Bolivian Corvair
> Reply-To: whubbell at umich.edu
>
> Hey, I see that my earlier post did not format well, so here is a  
> re-post of
> the parts that Richard is looking for (Bill Hubbell)
>
> "Corvair" insignia for sides of both front fenders.
>
> "Chevrolet" insignia for rear engine cover
>
> Front trunk cylinder
>
> Dashboard switch knobs
>
> Aluminum door sill plates
>
> Cowl vents & doors for kick panels (other than pics in the manual,  
> have no
> idea what goes in there)
>
> Windshield wiper arms
>
> 2 Interior door handles with washers
>
> 3 Window crank handles with washers
>
> Interior rear view mirror and mount
>
> Bumper guards
>
> Alternator/filter adapter  (NOTE: I also think we should get him a  
> CORVAIR
> alternator and Voltage Regulator or else a late model internally  
> regulated
> GM regulator with CORVAIR front frame and pulley.  He planned to  
> used a
> NISSAN alternator and modify the mount, but this would be easier.   
> GM parts
> are almost non-existent in Bolivia - wjh)
>
> High beam dimmer switch
>
> Turn signal internals and lever (all I have is the collar)
>
> Horn button
>
> Steering wheel bearing, seat and spring
>
> Cut valve covers for adjusting, or extras that can be cut
>
> Left and right air baffles and clips
>
> Thermostat
>
> Air tubes from air filter to carburetors (will use hoses if I can't  
> find
> tubes)
>
> Choke mechanism for air intake (can't find in any catalogs)
>
> Shroud pieces..  Still counting (comparing pieces to shop manual  
> photos)
>