<div><div>I don't remember seeing the shims but since they are kinda hidden behind the trans cross member I can't say that they were not there.  I do recall putting them in when we did his clutch job. Remember the clutch actuation issue was due to the clutch dust shield nylon washer being incorrectly installed.  It was binding in the bell housing preventing the clutch rod from getting full travel.  </div><div>Easy to check. Just need for someone to drop by Richards house and check for shims.  </div><div><br/></div><div>Good point Frank.  </div><div><br/></div><div><i><font style="color:#333333">Sent from my Verizon Wireless 4G LTE DROID</font></i></div></div><br><br>Frank DuVal via Novacc-list <novacc-list@corvair.org> wrote:<br><br>OK, It has been bothering me that there seemed to be no reason for the <br>sudden need to adjust Richard's clutch linkage.<br><br>When the bolts were found loose on the transmission to transmission <br>crossmember (mount), I asked if the shims were still in place. I didn't <br>hear an answer and got distracted.<br><br>So I ask again, were there shims between the transmission and the <br>mount/crossmember?<br><br>I've seen a 1/2" stack of shims to get the toe adjustment right. If the <br>bolts came loose and the shims fell out, then that would be a reason the <br>adjustment suddenly got off by a 1/2".<br><br>What a great meeting!<br><br>Frank DuVal<br>_______________________________________________<br>Novacc-list mailing list<br>Novacc-list@corvair.org<br>http://www.vv.corvair.org/mailman/listinfo/novacc-list<br>