PPCC List - Looking for special wrench

[David Feasel]

Jerry, I don't remember needing a special tool to take the mount off. I'll
have to see what size nut that is when I get back in the shop and I can
bend a box end wrench to fit. Steve Goodman may know what size that is.

On Wed, Dec 12, 2018, 3:10 PM JERRY PEEVYHOUSE via PPCC-list <
ppcc-list at corvair.org wrote:

> Hi there, my first post to the list, and it is a request to borrow a tool
> if someone has one.  I'm replacing both of my front trans mounts on my 65
> coupe and rather than spend $14 to buy this special wrench (C3772) from
> Clark's to use in changing the right side mount, was wondering if someone
> had one I could borrow. Getting to the top nuts I understand is not easy
> without this offset type wrench.
> I'm on the list, or you can reply to this email if you can help.  Would
> appreciate it.
> I'm having fun getting into the restoration, finding lots of "previous
> owner" issues, such as bad rear engine mount and missing bolts here and
> there.
> Thanks,
> Jerry Peevyhouse
>
>
> _______________________________________________
> This message was sent by the PPCCs mailing list, all copyrights are the
> property of the writer, please attribute properly.
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.vv.corvair.org/pipermail/ppcc-list/attachments/20181212/d02cc62c/attachment.html>