[V8Vairs] Rack and Pinion

[Al Kidd]

Bob Coffins kit which was in my Crown was from a 240Z or 260Z.  I didn't
like the feel of it so ended up pulling it and going back to stock.  Stock
is by far the simplest most effective set up in my opinion.

Jay Dover ran a Mustang II rack in his

-----Original Message-----
From: v8vairs-bounces at corvair.org [mailto:v8vairs-bounces at corvair.org] On
Behalf Of WytchMedea at wmconnect.com
Sent: Wednesday, March 23, 2005 8:44 PM
To: v8vairs at corvair.org
Subject: [V8Vairs] Rack and Pinion

I was wondering if there is anyone here who has installed a manual rack and 
pinion and could possibly tell me which rack is the most adaptable and fits
the 
Corvair's upper and lower control arm geometry.  My gas tank is not in so
the 
steering column linkage should not create too much of a problem as I am 
considering a fuel cell or a Mustang gas tank.  

Thanks.

Rob


_______________________________________________
V8Vairs mailing list
V8Vairs at corvair.org
http://www.vv.corvair.org/mailman/listinfo/v8vairs
This list sponsored by the Corvair Society of America,
http://www.corvair.org/

-- 
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.8.1 - Release Date: 3/23/2005
 

-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.8.1 - Release Date: 3/23/2005