[V8Vairs] Concentric slave cylinder/throw-out bearing

[Paul Strohl]

Hello george, i use a stock corvair brake master cylinder for the clutch and a howe hydraulic throw out bearing (available from summit racing). i have been using this setup for a few years now with no problems,it works fine. a couple of other v8 guys use the mccloud hydraulic throw out bearing and complain about how hard a pedal they have. hope this helps, paul paulstrohl at yahoo.com 66 corsa with 350 cu in 400hp small block crown conversion.

George Jones <georgedjones at gmail.com> wrote:  I've got the trans and diff out of my V8 at the moment, and rather than
dealing with the slave cylinder/release bearing & clutch fork, I was
contemplating swapping in a concentric slave/throw-out bearing. Only problem
is that the FLAPS has to have the year/make/model of the car. Needless to
say, I can't use the '65 Corvair for that. Does anyone know what application
works? Also, is there any modifications required to the standard Crown
set-up to have the concentric work?

Thanks,

-- 
__________________________________
George Jones
Corvair Society of America (Since 1987)
Tidewater Corvair Club (Since 1987)
Central Virginia Corvair Club (Since 2006)
'65 Monza Crown V8 Convertible http://www.cardomain.com/ride/2397326
'66 Monza Coupe (Custom in work)
__________________________________
_______________________________________________
V8Vairs mailing list
V8Vairs at corvair.org
http://www.vv.corvair.org/mailman/listinfo/v8vairs
This list sponsored by the Corvair Society of America, http://www.corvair.org/


 
---------------------------------
Food fight? Enjoy some healthy debate
in the Yahoo! Answers Food & Drink Q&A.