[V8Vairs] Corv-8 Seats for sale

Chris Wills cjwills at msn.com
Fri May 18 19:54:07 EDT 2007


I have a"Crown" seat for sale.  It is similar to the Crown, but deeper areas 
where you sit for more leg room.  Plus the fiberglass seat inserts, but no 
upholstery.  Never used, but was installed and nothched for the  Crown 
frame.  Also has a 9" X 9" cutout between the seats (for seatbelts?).

$75 plus shipping.

Chris Wills

(650) 368-5201



>From: "Brown, Douglas T CIV NAVAIR DEPT" <douglas.t.brown at navy.mil>
>Reply-To: discussion of non-stock engines in Corvairs <v8vairs at corvair.org>
>To: <v8vairs at corvair.org>
>Subject: [V8Vairs] Corv-8 For Sale
>Date: Fri, 18 May 2007 09:13:15 -0700
>
>This Corv-8 has the original Crown conversion kit already installed,
>with the HD rear springs, bell housing, flywheel, shift linkage, 4
>spider posi 3.55 rear, and sub-frame ready to drop your small block
>Chevy engine into.  Most of the hard work is already done.
>
>Body is straight and clean with the exception of 2 or 3 minor 1/4" rust
>holes on the left rear fender lip.  All glass is good.  Trunk floor is
>solid; driver's side floor was replaced.  The car has been stored
>indoors for 10 years, just recently set outside to make room for my
>other projects.
>
>Included in sale are an 8 point roll cage that cost over $1500, new
>front brakes, Crown headers, a custom bolt-on tow bar, spare front
>bumper, and all the trim that was removed from the car for paint.  Car
>is currently in primer.  It has a GM truck radiator mounted in the rear
>for that stealth quality, so your street competition won't know what you
>have until it's too late.  Interior door panels, arm rests, and handles
>are there.
>
>Not included with the sale are an engine, seats, carpet.  Car will have
>stock wheels and hubcaps.  Rear brakes need assembly.  Asking $1700.  I
>just listed it on eBay, so don't delay if you want it.  Pictures sent on
>request.
>
>Toby




More information about the V8Vairs mailing list