[V8Vairs] Vortec v6 Crown reduced to $4800

[Chris Wills]

What is that bent bar that appears to be connecting the left and right torque arms?
  ----- Original Message ----- 
  From: Sethracer at aol.com<mailto:Sethracer at aol.com> 
  To: v8vairs at corvair.org<mailto:v8vairs at corvair.org> 
  Sent: Saturday, June 30, 2012 5:15 PM
  Subject: Re: [V8Vairs] Vortec v6 Crown reduced to $4800


  No, Chris, it is a standard Corvair set-up, with the Crown mount on the  
  back of the rear axle and a modified front Crown crossmember. - Seth
   
   
  In a message dated 6/30/2012 4:37:54 P.M. Pacific Daylight Time,  
  cjwills at msn.com<mailto:cjwills at msn.com> writes:

  Looks  like a de Dion rear end - but I'm not going there again...
  Chris  Wills
  _______________________________________________
  V8Vairs mailing list
  V8Vairs at corvair.org<mailto:V8Vairs at corvair.org>
  http://www.vv.corvair.org/mailman/listinfo/v8vairs<http://www.vv.corvair.org/mailman/listinfo/v8vairs>
  This list sponsored by the Corvair Society of America, http://www.corvair.org/<http://www.corvair.org/>