<VV> EM Specific questions.

Shaun shaun_mcgarvey@shaw.ca
Fri, 20 Aug 2004 15:09:40 -0700


The rear crossmember is actually the same for 3spd and Powerglide. 4spd is
different.
So, you'll need the transmission support for a 4spd and the rear
crossmember, or use a torch to clearance.

yea, Vairily ... Shaun

----- Original Message ----- 
From: "Tony Underwood" <tonyu@roava.net>
To: <virtualvairs@corvair.org>
Sent: Friday, August 20, 2004 2:40 PM
Subject: Re: <VV> EM Specific questions.


> At 01:21 hours 08/20/2004 -0500, Kinzelman, Andy wrote:
> >Guys,
> >If I'm not mistaken, the EM 4 speed requires a different suspension
> crossmember, too.  Right?
> >Andy K.
> >_______________________________________________
>
>
> All of the "tin sidecover" 4-speed gearboxes ('61-'65) use the same front
> mount bracket.     The sub-frame member itself, the big chunk held in with
> the rubber "cup" mounts that the transmission mount bracket attaches to is
> the same for all transmissions.
>
>
> tony..
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
> _______________________________________________