<VV> Door speakers

[bob mccrum]

re: drill bit--the best brand name is uni-bit, comes in two common sizes i
know of-up to 1/2" and up to 1", good luck, bob mc
----- Original Message ----- 
From: "WH" <HiHal@adelphia.net>
Cc: <virtualvairs@corvair.org>
Sent: Sunday, December 05, 2004 10:24 PM
Subject: Re: <VV> Door speakers


> Marc Sheridan wrote:
>
> > I found out from Mark Corbin that Clarks has repros of the original
> > rubber accordion boots. Although they are rather pricey, I bought them
> > because I didn't have an alternative. Mark said that Clarks has
> > instructions for installation, but they told me they didn't. However
> > Mark told me where the holes go. They require an 11/16" hole, which is
> > an odd size. A drill bit that size needs at least a half inch chuck
> > and most hole saws don't go smaller the three quarter.
> >
> > Anyone out there have a source for an 11/16 hole saw or any other
> > method to get a hole that size?
> >
> > Marc Sheridan
>
> You need a step drill bit. I have seen them in Harbor Freight catalogs
> and HF now has a store near the W. Broad exit off I-270 in Columbus.
>
> Wade
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
>  _______________________________________________