<VV> Thread repair problem solved

VairMech@aol.com VairMech@aol.com
Wed, 2 Jun 2004 13:14:19 EDT


In a message dated 6/2/2004 12:53:34 PM Eastern Standard Time, 
GYoungwolf@aol.com writes:
For 
those interested, the drill size needed was a 17/64", but I have not been 
able to ascertain the tap size yet. Kit was also 20% cheaper than at the LAPS 
>>>>>>>>>>>>>>
    The tap size for the 1/4-20 helicoil is a special size but it is very 
close to a 5/16-20 tap size. I know they don't make that size!
    Ken Hand