<VV> Re: Floorboards

VairMech@aol.com VairMech@aol.com
Mon, 31 May 2004 17:45:07 EDT

In a message dated 5/31/2004 5:25:39 PM Eastern Standard Time, 
vairologist@juno.com writes:
Smitty says:  If you are looking for easy, quit now Ron.  The biggest
asset I found was a pneumatic chisel from one of the cheepo tool places. 
Twenty bucks or so.  Grind a chisel into a shallow "V" so it will feed to
the center rather than trying to skip off what you are cutting
    Has it been a while since you have been to a tool store? (BIG GRIN!) They 
have that style of cutter already made along with several others made to cut 
sheet metal with a clean edge.
    Ken Hand