<VV> NOS Clutch Cable Installed: Problem STILL Not Solved

[J R Read_HML]

If it IS the pilot bushing... which seems quite likely...  you MIGHT want to 
consider installing one of the roller bushings upon re-do.

Attachments are scanned with anti-virus software.

Later, JR
----- Original Message ----- 
From: "Shaun" <shaun_mcgarvey@shaw.ca>
To: <virtualvairs@corvair.org>
Sent: Wednesday, October 06, 2004 11:10 PM
Subject: Re: <VV> NOS Clutch Cable Installed: Problem STILL Not Solved


> <Smit>
>> The input shaft seemed very tight when I fit it into the pilot bushing. 
>> I
> think that this might be where the problem is.
>>
>> Charles
> <unSmit>
>
> Yes, this is the problem! When you drove the bushing in, you mushroomed 
> the
> end enough to make the shaft too tight. You needed to pull the shaft out a
> little and wallow out the end of the bushing slightly before proceeding.
>
> yea, Vairily ... Shaun
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
> _______________________________________________