<VV> Corvair half shafts...

[N. Joseph Potts]

I don't know anything about torque tubes. Was there ever one on a Corvair?
If not: (a) please don't answer this message; and (b) don't post any more to
this forum about them. If there was, then please by all means fill us in.

Joe Potts

-----Original Message-----
From: virtualvairs-admin@corvair.org
[mailto:virtualvairs-admin@corvair.org]On Behalf Of JVHRoberts@aol.com
Sent: Sunday, October 31, 2004 5:48 PM
To: YENBAT@aol.com; RoboMan91324@aol.com; virtualvairs@corvair.org
Subject: Re: <VV> Corvair half shafts...


All I was saying is, there are several modern iterations of the torque tube
that do NOT use solid shafts. And for good reason, that's all...


In a message dated 10/31/2004 5:33:20 PM Eastern Standard Time, YENBAT
writes:
You went way out on a tangent from where I was coming from...

Torque tubes used SOLID drive shafts.

That was my sole point

Tim Abney
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs@corvair.org
List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
 _______________________________________________