<VV> Front end help needed

[Ewell Mills]

    Thanks to all who replied with helpful hints on questions that I posed on
front end work.  Harry Yarnell's suggestion on removing the entire draglink to
replace the pitman arm bushing was right on.  It may be possible to do it on
the car, but much easier with it on the bench.  I was unable to find any new
upper ball joints in stock at any of the local FLAPS, but did find some tie
rod end dust covers that fit to replace the ones that were busted on mine.
They don't seal the joint completely like the original dust caps, but do allow
excess grease to come out to keep from bursting them if to much grease is
pumped in.  Again, thanks for all the helpful suggestions from all who
replied.

Cecil Mills
Cocoa, Fl.