<VV> Re: Brakes.

[Chris C, Warwick RI]

If it was a wheel cyl.  Use a dremel to cut a notch in the bolt.  Then a 
screw driver.


At 10:56 PM 6/2/2005, you wrote:
>In a message dated 6/2/2005 6:20:59 PM Pacific Daylight Time,
>corvair at mail.com writes:
>
> > I recently began working on the brakes of my newly acquired '65 Corsa
> > Coupe, because I needed to replace the front left wheel cylinder. Long 
> story
> > short, I ended up completely stripping the nut on the steel line flare 
> fitting in
> > the wheel well.  Has this ever happened to anyone else? Does anyone 
> have any
> > recomendations as to how to undo the fitting with a perfectly round 
> fastener?
> > I
>******************************************************************************
>**********
>
>Vise Grips!
>
>PS   do  not post VV  mail to vv-help......which is for email problems only!
>
>
>Matt Nall
>Chairman Virtualvairs / VV-talk
>  _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are 
>the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________