<VV> Where does the small wiring harness from temp sensor and oil pressure sensor go?

[Joe West]

Hi Geoff,

Thanks!  The picture you provided is perfect.  I'll head out now to make
sure that I have that same hole and an appropriate grommet :D

Joe

On 3/22/05 9:09 AM, "Geoffrey A. Johnson" <geoffj at unm.edu> wrote:

> Hi Joe,
> It runs through a grommet in a 1 inch size hole in the rear sheetmetal
> piece for the back of the right hand head.  Below and to the left of the
> coil.
> 
> Look at this picture of the engine in my corsa.
> 
> http://www.unm.edu/~sbuna/66corsa/images/engwshroud.jpg
> 
> It is the open 1 inch hole appearing below the distributor in the picture.
> Hope that helps!
> Geoff Johnson
> 
> --On Tuesday, March 22, 2005 8:34 AM -0700 Joe West <joew at diveaz.com> wrote:
> 
>> All,
>> 
>> I am getting ready to install a new wiring harness (very small) that goes
>> from the main engine bay wiring harness to the right cylinder temperature
>> sending unit and oil pressure sending unit.
>> 
>> My old harness was destroyed... And now I'm at a memory loss to figure out
>> where the harness transitions from the top of the engine to the right hand
>> side temperature sending unit.  The oil pressure connection is a piece o
>> cake and so is the plug in to the main engine bay harness... The problem
>> is that I can't figure out where the wire that goes to the right hand
>> side head should go through the sheetmetal to get from the top of the
>> engine to the sending unit on the head.
>> 
>> Can someone describe where this wire goes through the sheetmetal?
>> 
>> Kind Regards,
>> 
>> Joe West
>> 
>> 
>>  _______________________________________________
>> This message was sent by the VirtualVairs mailing list, all copyrights
>> are the property of the writer, please attribute properly. For help,
>> mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
>> America, http://www.corvair.org/ Post messages to:
>> VirtualVairs at corvair.org
>> Change your options:
>> http://www.vv.corvair.org/mailman/options/virtualvairs
>>  _______________________________________________
> 
> 
>