<VV> Rebuild II / Platigauge Instructions
UltraMonzaWest at aol.com
UltraMonzaWest at aol.com
Wed Mar 23 23:26:00 EST 2005
You cut the strip as long as the bearing is wide....no OIL! lay the case
half on the studs...install bearing shells in that case
Lay crankshaft in....do not rotate!
Insert bearing halves in next case half......set on top....torque!
Dismantle.....
lift out crank
lay envelope across smashed platigauge strip.......move until width matches
markings!
Measurements are in ONE HALF THOUSANTHS OF AN INCH INCREMENTS
As far as what you want......clearance.....you decide....but you MUST have
clearance!
Matt Nall / Patiomatt / WCUH / Chairman V V
69 Monza Cpe., 66 Monza vert, 65 Crown v8 Cpe.
Somewhere between Reno, NV and Coos Bay, Or.
More information about the VirtualVairs
mailing list