<VV> deflashing advice

[J R Read_HML]

I wonder if anyone might have pix of before and after deflash - maybe with a 
light on the far side - so that folks with this question would have a 
reference point?

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: <BobHelt at aol.com>
To: <dreamwoodck at yahoo.com>; <virtualvairs at corvair.org>
Sent: Monday, November 07, 2005 12:18 PM
Subject: Re: <VV> deflashing advice


> In a message dated 11/7/05 11:15:15 AM US Mountain Standard Time,
> dreamwoodck at yahoo.com writes:
>
>> I wonder:
>> Is the area between the top fin and the outside, solid portion of the 
>> head
>> supposed to be completely sealed all the way across? I've been unable to 
>> stab
>> through with a stiff drywall saw blade and it feels pretty solid.
>>
>
> Chuck,
> I don't have a head available for checking. But please don't try to stab 
> (or
> drill) thru any places. All deflashing can be done thru and around the 
> already
> OPEN slots.
> Regards,
> Bob Helt
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________