<VV> Electric oil pressure sender

[J R Read_HML]

You can T from the temp/press hole, but there is not a lot of room and you 
need to keep in mind that a thrown belt could potentially create an oil 
geyser.

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: "Cliff Tibbitts" <tibbitts at qx.net>
To: <virtualvairs at corvair.org>
Sent: Saturday, November 26, 2005 9:10 AM
Subject: <VV> Electric oil pressure sender


> Anyone using an electric oil pressure unit?  Where did you mount the 
> sender?
> Anyone want to post a picture?  There was a lot of talk back in October of
> the pros and cons of the mechanical versus the electric.  I've wanted the
> electric all along, but man it's a tight squeeze.  I know I am going to 
> have
> to do some plumbing in order to make it work.  Just looking for some
> suggestions.  Thanks in advance.
>
> Getting close to making some noise finally. I just hope the darned thing
> doesn't bounce out the door when I start it up.
>
>
> Cliff Tibbitts
> Lexington, KY
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________