<VV> Help!! crank rotation question...

Cash Case cash.case at sbcglobal.net
Sat Oct 29 14:59:14 EDT 2005

Also... just in case anyone has too take the head stud nuts off and  
they don't want the studs to turn. I use a set of vice grips clamped  
to the stud on the outside edge of the cylinder. This keeps the studs  
from turning.
-Just a tip-

On Oct 29, 2005, at 1:53 PM, Cash Case wrote:

> Yes, i took the top off the motor and I could not see any studs  
> that appeared to be hitting crank.
> -Cash
> On Oct 29, 2005, at 12:36 PM, BBRT wrote:
>> I would take the top off the block and look inside and see if rod  
>> bolts clear studs, in case there is one that was in too far.  But,  
>> when you pulled that head, you may have turned the stud a bit out,  
>> so it doesn't interfere...  Kind of need to make sure and it will  
>> be hard to spot, that something didn't hit.
>> Chuck S

More information about the VirtualVairs mailing list