<VV> Re: - End Casting

[Robert Paul]

Thanks for the assitance, I'll give it a try Thursday.
Then in a few weeks I'll be asking for more help.
All the best 
Robert Paul

----- Original Message -----
From: BBRT <chsadek at adelphia.net>
Date: Tuesday, December 19, 2006 6:24 pm
Subject: Re: - End Casting

> You must remove the distributor.  The lower end is like a thick 
> flat/slotted 
> screwdriver which fits in the oil pump, located in the rear 
> housing.  You 
> should be able to easily tap and remove the rear housing.
> 
> Good Luck
> 
> Chuck S
> ----- Original Message ----- 
> From: "Robert Paul" <barnaby at shaw.ca>
> . Secondly, to remove the end casting from the block, do I need to 
> remove 
> the distrubutor?  I think I have all of the bolts rmoved but the 
> casting is 
> on tight, I did not try to hit it with a bigger hammer, .  Any 
> help on this 
> one?
> > Thanks again
> 
>