<VV> Clutch Cable Saga III

[Jim McLott]

At the risk of violating the "No Me-Too Posts" rule, let me second Ned's
advice.  EZ-outs are only good for removing boogered-up wood screws.  A
broken EZ-out is almost impossible to remove.  DAMHIK.

Jim McLott & Christine, the 1966 Monza convertible wonder-car
Member: CORSA, Corvair Atlanta and Group Red (Ret.)
http://www.wittelaw.com/personal/groupred/mclott.htm


-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of AeroNed at aol.com
Sent: Wednesday, October 04, 2006 9:40 PM
To: virtualvairs at corvair.org
Subject: Re: <VV> Clutch Cable Saga III

 
In a message dated 10/4/2006 2:59:06 P.M. Central Daylight Time,  
minoxphotographer at yahoo.com writes:

I'll  ezout that sucker,


Chances are that if the bolt is that stuck, an ez-out won't get it out.
In  
fact it will most likely break off inside the bolt. The ez-out will be
much  
harder to drill out than the bolt. My advice is to just drill out the
bolt and  
be done with it...
 
Ned
 _______________________________________________