<VV> EM Rear Seat Belt Installation

[Ron]

And the dimples are located by looking at the diagrams in the applicable 
accessory manual.
RonH

----- Original Message ----- 
From: "EVERETT WILSON" <aircooled6 at prodigy.net>
To: <bowtieguy at cox.net>; <virtualvairs at corvair.org>
Sent: Thursday, September 07, 2006 3:11 PM
Subject: Re: <VV> EM Rear Seat Belt Installation


>I think I have read here on vv that there are "dimples" in the floorboards 
>where the holes should be drilled.  Its been a while since I had an early 
>car.
>
>  Everett Wilson
>  North Richland Hills TX
>  64 Brier - Rear Belts on the project list!
>  67 4 dr - had them already
>
> bowtieguy at cox.net wrote:
>  Does anyone have a diagram indicating the proper location of rear seat 
> belts for a '64 convertible to share?
>
> Thanks,
>
> Bob Vukas
> '64 Monza Convertible
> bowtieguy at cox.net
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>