<VV> silicone brake fluid
Sethracer at aol.com
Sethracer at aol.com
Fri Jun 22 02:13:41 EDT 2007
In a message dated 6/21/2007 11:09:44 PM Pacific Daylight Time,
hmlinc at sbcglobal.net writes:
Silicone is JF. Just be sure you have EVERY spec of the DOT3 out of the
entire system first. Some say to flush with alcohol. I don't know. I've
put in Silicone after replacing a whole bunch of parts first - lines, MC,
Wheel Cs (or rebuilds).
Later, JR
Also be careful about flushing with air - Most home compressors (Those that
aren't often used for real painting) have no way to remove or lessen the water
that enters the compressor. If you have appropriate filters or driers, air
will help clean out the lines. Most DOT 5 and DOT 3 fluids won't mix, but the
DOT 3 will retain moisture, attract it even, and if it sits at a low point in
the system, "rust never sleeps" - Seth
************************************** See what's free at http://www.aol.com.
More information about the VirtualVairs
mailing list