<VV> Carb problem 63

[Chris C, Warwick RI]

Forgot to say it, but I did that.  Have a test line I made.  The correct 
connections on each end of a flexible hose.  No chance of constriction. 
Would not run it far like that, but it eliminates the crimped/blocked line 
as a culpret.

At 11:47 AM 3/26/2007, you wrote:
>Looks like you have most the bases covered.  Pull the line to the ofending 
>carb and make sure it is not blocked.
>
>T. Kalp
>
>---- "Chris C wrote:
> > Here are the symptoms.
> >
> > Car will start, but will not stay running, have to re-start several times
> > to get it warm enough to stay running.   If I have an assistant CPR'ing 
> the
> > passanger side carb it will stay running until warm.
> >
> > Once its warm it runs ok.  Put hand over either carb, intense pulling and
> > car wants to stall.  If I pump it a few times the drivers side squirts gas
> > (nice gas fog), the passenger side does not.
> >
> > Swapped for another carb.  Same symptoms, but the carb was not a known 
> good
> > one.
> >
> > Ordered deluxe rebuild kits, and rebuilt the orig carb.  In doing so I 
> found:
> >       The carb was not filled with junk.
> >       2 wholes on the accel pump were plugged
> >       The choke pull of was not holding vac
> >       The float drop was completely mis adjusted by about 1/8 of an inch.
> >
> > Before I re-start I was going to replace the inline fuel filter in the
> > wheel well.
> >
> > Anything else that would contribute to the lack of gas to 1 carb.
> >
> > Thanks to all.
> >
> >
> >  _______________________________________________
> > This message was sent by the VirtualVairs mailing list, all copyrights 
> are the property
> > of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> > This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> > Post messages to: VirtualVairs at corvair.org
> > Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> >  _______________________________________________