<VV> Input Shaft Seal

[BBRT]

Sharp small chisel and cut it. Then it will come out easier. Try not to 
scratch the seal area. If you do, use a sealer on outside of seal.
----- Original Message ----- 
From: "Ian Harding" <harding.ian at gmail.com>
To: "Virtual Vairs" <virtualvairs at corvair.org>
Sent: Saturday, September 15, 2007 9:09 PM
Subject: <VV> Input Shaft Seal


> I'm trying to get the bloody thing out and it won't budge.  I've read
> the warnings about prying on the outer shaft, so I'm not doing that,
> but I have tried a clothes hanger hook, and a hillbilly slide hammer
> made of an old head stud and big socket, but it won't move.
>
> Any suggestions appreciated.
>
> - Ian
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________