<VV> 110 jugs on a 95 block

[Jonathan Lawler]

hey y'all. i'm rebuilding the enigne in my 1966 corvair. it's a stock 95.
however, i have a 110 out of a 95 monza that i had ripped down. i was
wondering if i could use the cylinder jugs from the 110 and put them on the
95 block. if the jugs were the same then i could use 95 pistons and rods
when i buy a new set, right? or can i go ahead and buy 110 pistons and bring
the horsepower up a little bit. i'd like to keep the stock engine/block, but
more horsepower is always a good thing. also, is the crankshaft the same on
both engines, or was that changed also? how did GM get that extra 15
horsepower from the 95 and turn it into a 110?

-- 
-jon