<VV> rear quarter panels

[J R Read_HML]

Hmmmm...   The vendors have replacement rockers which you will surely need 
if the body is that bad.  Remember that the rockers hold the front and back 
halves together on a vert.  For body panels, you could try Phoenix Charley, 
but I understand he is sometimes hard to reach.  Keep in mind that coupe 
body panels could also be used.  Just how far gone IS this car.  Perhaps it 
is nearing donor status for someone else's car?

Later, JR

----- Original Message ----- 
From: "Robert Paul" <barnaby at shaw.ca>
To: <VirtualVairs at corvair.org>
Sent: Tuesday, December 30, 2008 3:54 PM
Subject: Re: <VV> rear quarter panels


>I am redoing the body on my 66 monza convertable and the rear quaters are 
>in tough shape, but the worst is a strech from the door to the rear wheel 
>well.  Does anyone know where I can get metal replaceemts for these areas, 
>passenger side for sure, driver side is better, but both would be great.
>
> Thanks
>
> Robert Paul
> 66 Monza
> 65 Corsa
> 66 Corsa
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________