<VV> Steel threads in aluminum

[Rick Norris]

He used a Bohunk torque wrench, sometimes called a "Murphy bar" or six foot 
section of pipe!
TLH

> Soooo you have done it already and didn't use a torque wrench ??? <GGG>
>
> FrontMan
> WTBRT PR
> ////////////////////////////////////////////////////////////////////////////
>
> At 02:58 PM 1/10/2008, you wrote:
>>How much force will it take to pull a head stud out of an aluminum
>>case? Head stud is 3/8-16 interference fit in the aluminum case.
>>Assume the aluminum is "new".
>>
>>Thanks
>>
>>Chuck S
>>BBRT
>>  _______________________________________________
>>This message was sent by the VirtualVairs mailing list, all
>>copyrights are the property
>>of the writer, please attribute properly. For help, 
>>mailto:vv-help at corvair.org
>>This list sponsored by the Corvair Society of America, 
>>http://www.corvair.org/
>>Post messages to: VirtualVairs at corvair.org
>>Change your options: 
>>http://www.vv.corvair.org/mailman/options/virtualvairs
>>  _______________________________________________
>
> CORSA Tri-membership Chairman
> CORSA Member
> Corvanatics Member
> Corvair Atlanta Director
> SECC Member
> 1965 Corsa Coupe
> 1964 Greenbrier
> 1965 Corsa Autocross car 1/2 owner
> http://darthvair.com
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.516 / Virus Database: 269.19.0/1218 - Release Date: 1/10/2008 
> 1:32 PM
>
>