<VV> MODULATOR /GM fuel inlet TOOL

[Ron]

Geez!  Just get any cheap stamped one inch open end wrench and it'll work 
fine.  I look in the scrap wrench boxes at swap meets.  You can find them 
stamped out of 1/8" stock.
RonH

----- Original Message ----- 
From: <N2VZD at aol.com>
To: <virtualvairs at corvair.org>
Sent: Thursday, January 24, 2008 1:55 PM
Subject: Re: <VV> MODULATOR /GM fuel inlet TOOL


>i use the same wrench on the modulator as the fuel inlet on carbs , a matco
> thin open end wrench sold to do inlet nuts on gm carbs. it works very 
> well.
> if needed, i will get the number and take a picture later, i am on my  way
> out to a meeting now.
> regards, tim colson
>
>
>
> **************Biggest Grammy Award surprises of all time on AOL Music.
> (http://music.aol.com/grammys/pictures/never-won-a-grammy?NCID=aolcmp003000000025
> 48)
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>