<VV> lm flex plate bolts

[BobHelt at aol.com]

In a message dated 6/9/2008 10:40:49 AM US Mountain Standard Time,  
cfmann at yahoo.com writes:

My only  question really now is, just how much "slop" should I see? I 
approximate the  nut to be about 1/2" and the square hole about 5/8". Not sure 
(because of my  inexperience) if this relationship should be tighter? like near zero 
 tolerance?
the round hole in the plate itself does not look elongated or  oval shaped 
(pshew!) 



Chris,
The flex plate should be up-tight against the TC.
Regards,
Bob Helt



**************Vote for your city's best dining and nightlife. City's Best 
2008.      (http://citysbest.aol.com?ncid=aolacg00050000000102)