<VV> Special Tools

[Jim Danner]

I seperated the differential and powerglide to replace a side bearing on my 65 Sedan.  I was all set to put them back together when I read this in the shop manual:  
 
"1.  Prior to reassembly of the differential carrier to the Powerglide transmission after any repair which required separation of these units, perform the procedures outlined below to determine the thrust washers required at the front face of the governor gear.
 
"Stritct adherence to the procedure outlined below is mandatory to insure Powerglide internal running clearance of .025" - .045".  If transmission is assembled with less clearance, transmission failure is probable.
1.