<VV> FC DRIVER'S DOOR LATCH & STRIKER

[shortle]

I seem to remember on my '63 Rampside there was at 1 point too much old, crusty grease and just cleaning it all off (inside and out) and then relubing it with lubriplate and then a couple of good slams it all of a sudden starting working properly again. As far as interchanging with an early, I don't think so. I hope this is helpful.
Timothy Shortle in Durango Colorado

-----Original Message-----
>From: Rod Murray <rmurray at anaheimducks.com>
>Sent: Apr 13, 2009 3:51 PM
>To: "'virtualvairs at corvair.org'" <virtualvairs at corvair.org>
>Subject: <VV> FC DRIVER'S DOOR LATCH & STRIKER
>
>
>Looking to either fix or replace the driver's door latch and/or striker on my '64 greenbrier.  Bottom line is it will not completely latch and shut - only connects to the point where the door is "cracked"...any repair suggestions?  Also, are latch and striker universal w/ EM vairs, or limited to FC's only?
>
>Many thx,
>
>Rod
>'64 brier project
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________