<VV> 62 Disassembly

[Frank DuVal]

The plug is "plugged" into the inner fender like a rubber grommet. There 
is a groove in the plug and the sheet metal hole is slightly smaller 
than the OD of the plug, but the same size as the groove. Just use a 
small screwdriver or other pry tool to gently work the plug through the 
hole. It WILL go.

Frank DuVal

Ed Orbea wrote:

>I am starting to disassembly by 62 Monza Coupe in preparation for final 
>body work and paint. I have the 62 assembly manual, but it is no help 
>for this specific question.
>When attempting to remove the rear tail lights (the turn/stop not the 
>backup) the wiring harness goes from the light assembly to a rubber male 
>plug on the rear inner fender. While I can disconnect the wiring harness 
>at the plug, I cannot figure out how to remove the plug from the inner 
>fender or disconnect the wires that run from the light assembly to the plug.
>
>So what is the trick to removing the lights?
>
>Ed Orbea
>'62 Monza
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>
>  
>