<VV> WC: pressure regulator
Western Canada CORSA
westerncanadacorsa at shaw.ca
Sat Jul 11 19:54:02 EDT 2009
When Mike's failed it was squirting fuel out of the hole in the middle of
the dial all over the engine compartment. (it's usually covered by a
sticker)
Regards,
Joel
-----Original Message-----
From: corvairs-owner at cybrus.net [mailto:corvairs-owner at cybrus.net] On Behalf
Of Matt Nall
Sent: Saturday, July 11, 2009 4:47 PM
To: corvairs at cybrus.net; virtualvairs at corvair.org
Subject: Re: WC: <VV> pressure regulator
-------------------------------------------------------------------
From the Western Canada Corsa list server at corvairs at cybrus.net
-------------------------------------------------------------------
Interesting!! Seems like only the screws could come loose on the
round cheapies... I've run them for decades... nothing else to cause /
allow a leak!
Matt Nall
Charleston, Oregon
http://mysite.verizon.net/nalllm
-----Original Message-----
From: Bob Gilbert <bgilbert at redshift.bc.ca>
To: 'Matt Nall' <patiomatt at aol.com>; virtualvairs at corvair.org
Cc: corvairs at cybrus.net
Sent: Sat, Jul 11, 2009 3:44 pm
Subject: RE: WC: <VV> pressure regulator
-------------------------------------------------------------------
From the Western Canada Corsa list server at corvairs at cybrus.net
-------------------------------------------------------------------
Hi Matt,
Good suggestion but the pump was for carbureted engines and was not an
EFI
pump. I bought it a few years back for $30 or so and I'm fairly certain
it
was rated at 6 psi.
Also, it worked for 3,000 plus miles and I'm guessing that had it had
been
an EFI pump, problems would have shown up before now.
All that being said, I will double check.
What I'd really like to be able to buy would be an integrated
pump/regulator
so I could keep the engine bay looking stock.
Bob
-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Matt Nall
Sent: July-11-09 3:59 PM
To: virtualvairs at corvair.org
Subject: Re: <VV> pressure regulator
Bob, what pressure is your PUMP putting out?
Many today put out 15-80 psi! for FI engines. If you asked for "The
best" most likely what you bought!! typical blunder...
Just buy another fuelpump... Steve Goodman has used the Airtech 1-4 psi
pump on customers cars for decades..
Matt Nall
Charleston, Oregon
http://mysite.verizon.net/nalllm
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights
are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options:
http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________
-------------------------------------------------------------------
All messages posted to this mailing list are the responsibility of the
author. www.Cybrus.net assumes no responsiblity for content. The WCC
mailing list server is sponsored courtesy of www.Cybrus.net, a division of
Optrics Inc. Any financial support is appreciated. For list instructions
such as how to unsubscribe, send an email to imailsrv at cybrus.net with Help
Corvairs as the body of your message.
-------------------------------------------------------------------
-------------------------------------------------------------------
All messages posted to this mailing list are the responsibility of the
author. www.Cybrus.net assumes no responsiblity for content. The WCC
mailing list server is sponsored courtesy of www.Cybrus.net, a division of
Optrics Inc. Any financial support is appreciated. For list instructions
such as how to unsubscribe, send an email to imailsrv at cybrus.net with Help
Corvairs as the body of your message.
-------------------------------------------------------------------
More information about the VirtualVairs
mailing list