<VV> Friction Stir Welding (no specific Corvair)

jvhroberts at aol.com jvhroberts at aol.com
Wed Oct 21 10:55:44 EDT 2009

 That's EXACTLY how the shaft and turbine wheel are mated in pretty much every turbo out there. Also, heads of exhaust valves to their stems, pushrod balls to the pushrod, etc. 


John Roberts


-----Original Message-----
From: J R Read_HML <hmlinc at sbcglobal.net>
To: VirtualVairs AA <VirtualVairs at corvair.org>
Sent: Wed, Oct 21, 2009 10:45 am
Subject: <VV> Friction Stir Welding (no specific Corvair)

I found this interesting and thought others on VV would also.


Be sure to read the information below the picture.  Made in America?

Later, JR

This message was sent by the VirtualVairs mailing list, all copyrights are the 
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 


More information about the VirtualVairs mailing list