<VV> Replacing FC Ventilator Window Weatherstrip

[Dan & Synde]

Hi Ron,

Under the rubber on the top of the frame are two rivets that hold the top
side of the pivot.  Drill those out, install the rubber and then put in two
pop rivets to replace them.  19 years and mine is still holding firm and the
seal is still working great.

Dan Kling

1961 Greenbrier Deluxe, 4spd, 3.89  On the Road Again,  yeehaw :)
1963 Spyder, restored   4spd Saginaw
1967 Ultravan #299  Newest of the herd!! Almost killed me already!!


http://www.flickr.com/photos/81412237@N00/sets/
A few pictures of the Greenbrier, UltraVan, engine and tranny tear down with
more to come!


RonH said
>How does one install a new molded weatherstrip for a FC ventilator window?
The friction spring assembly is supposed to go >through a hole in the
rubber.  Should the pivot rivet be drilled out so the window can be removed
or does one cut the super >expensive weatherstrip on the inside so it can go
around the lower pivot?